Barbell Row

The barbell row is a compound barbell exercise. It mainly works the lats and also trains the traps, rear delts, biceps, forearms, lower back. Barbell bent-over row for back thickness and lat development.

Main muscle
Lats
Also works
Traps, Rear delts, Biceps, Forearms, Lower back
Equipment
Barbell
Type
Compound (several joints)
Level
Intermediate
Movement
Row
Barbell Row with the lats highlighted

How to do the barbell row

The barbell row is a bent-over row where you pull a barbell to your lower ribs from a hip hinge. It trains the lats, with the traps, rear delts, biceps, forearms and lower back helping. It suits intermediate lifters who can hold a flat back under load.

Setup

  1. Stand with your feet about hip width apart and the bar over your mid-foot.
  2. Grip the bar with both hands, overhand, a little wider than shoulder width.
  3. Lift the bar to your thighs, then hinge at the hips with soft knees.
  4. Lean your torso forward until it is close to parallel or at about 45 degrees.
  5. Let the bar hang at arm's length below your shoulders with a flat back.

One rep

  1. Brace your core and take a breath.
  2. Pull the bar toward your lower ribs by driving your elbows back.
  3. Squeeze your shoulder blades together at the top.
  4. Lower the bar under control until your arms are straight.
  5. Keep your torso angle the same through the whole set.

Common mistakes

  • Standing up as you pull turns the row into a shrug, so keep your torso angle fixed.
  • Rounding the lower back puts the load on the spine, so brace hard and reduce the weight if your back bends.
  • Jerking the bar with your hips uses momentum, so pull with your back and stay still from the hips.
  • Pulling the bar to your chest moves the work to the upper back, so aim for the lower ribs to keep it on the lats.

Tips

  • Take a breath and brace before each rep. Breathe out at the top or after the bar comes down.
  • Pick a weight you can row without changing your torso angle.
  • Lower the bar in about two seconds to keep tension on your back.

Sets and reps

Do 3 to 4 sets of 6 to 10 reps. Use it early in a back or pull workout as a main horizontal pull.

Muscles worked

The main muscle is the lats. It also trains the traps, rear delts, biceps, forearms, lower back. In FORCE, each set you log counts toward the recovery of the main muscle, and a share counts toward the helper muscles.

How FORCE coaches the barbell row

  • Next-set weight. Log the weight, the reps and the reps you had left. FORCE gives the weight for your next set. How the coach works
  • Recovery. Your sets update the ready time of the lats. Recovery in FORCE
  • Warm-ups. FORCE plans warm-up sets from your working weight.
  • Swaps. If a helper muscle is not ready, the coach suggests another exercise for the lats.

Track the barbell row in FORCE