How to do the iso-lateral kettlebell row
The single-arm kettlebell row is a row done in a split stance with your free hand braced on your thigh. It trains the lats, with the traps, rear delts and biceps helping. It suits beginners because it needs only one kettlebell and no bench.
Setup
- Take a split stance with your non-working leg forward.
- Hinge forward from the hips until your torso is well inclined.
- Brace your free hand on your front thigh.
- Hold the kettlebell in your working hand with your arm hanging straight down.
One rep
- Brace your trunk and keep your back flat.
- Pull the kettlebell toward your hip, driving your elbow back close to your body.
- Squeeze your back at the top.
- Lower the kettlebell under control until your arm is straight.
- Finish your reps, then switch sides.
Common mistakes
- Twisting the torso to lift the weight, so keep your shoulders square and your torso still.
- Rounding the back, so keep it flat from hips to head.
- Dropping the kettlebell fast, so lower it over 2 seconds.
- Shrugging the shoulder up, so drive your elbow back toward your hip.
Tips
- Breathe out as you pull and breathe in as you lower.
- Pause for one second at the top of each rep.
- Pick a kettlebell you can row for every rep without moving your torso.
Sets and reps
Do 3 sets of 8 to 12 reps per arm. Use it as a main row or after a heavier pull in a back session.
Muscles worked
The main muscle is the lats. It also trains the traps, rear delts, biceps. In FORCE, each set you log counts toward the recovery of the main muscle, and a share counts toward the helper muscles.
How FORCE coaches the iso-lateral kettlebell row
- Next-set weight. Log the weight, the reps and the reps you had left. FORCE gives the weight for your next set. How the coach works
- Recovery. Your sets update the ready time of the lats. Recovery in FORCE
- Warm-ups. FORCE plans warm-up sets from your working weight.
- Swaps. If a helper muscle is not ready, the coach suggests another exercise for the lats.








